Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

project salvo response trigger

 Post Reply Post Reply
Author
axlf123 View Drop Down
Member
Member
Avatar

Joined: 04 January 2012
Location: new york
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote axlf123 Quote  Post ReplyReply Direct Link To This Post Topic: project salvo response trigger
    Posted: 04 January 2012 at 7:57pm
ok so i just installed my response triger into my project salvo just as every video online said and as the pictures descripted....i took a c02 tank and hooked it up and fired off a couple shots to see if it would work but it would not shoot automatic......im not sure why its not working, i was thinking because there is not much air at all left in my tank but i dont know.....also would anyone happen to know how to program an intert too halo hopper in like simply
Back to Top
bc5rm125 View Drop Down
Member
Member
Avatar

Joined: 22 January 2012
Location: Leonardtown MD
Status: Offline
Points: 9
Post Options Post Options   Thanks (0) Thanks(0)   Quote bc5rm125 Quote  Post ReplyReply Direct Link To This Post Posted: 23 January 2012 at 10:21pm
Not to sure but I know my friend was using a tippmann 98 custom pro and his response trigger wouldn't work unless it had 3/4 co2 so it might be because of a low tank, also did you hammer out the pin where you plugged the gasline from the piston into your gun. I'm just guessin since I've never had a response trigger and definitely don't know anything about the halo hopper so I'm probably wrong but good luck.
Back to Top
TippmannEmployee1 View Drop Down
Tippmann Tech
Tippmann Tech

Tippmann Sports Staff / Marker Guru

Joined: 10 May 2010
Location: Fort Wayne
Status: Offline
Points: 158
Post Options Post Options   Thanks (0) Thanks(0)   Quote TippmannEmployee1 Quote  Post ReplyReply Direct Link To This Post Posted: 30 January 2012 at 3:17pm

I would start with a full tank. Also check for any loose fittings or damaged O-rings in the banjo fittings. Start off with the flow control adjustment turned all the way in. When you pull the trigger it should get very stiff if your RT kit has no leaks. Also watch our video on how to adjust the RT System. http://youtu.be/xGpaIgpOc7E

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.078 seconds.