Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

act pins cracking case

 Post Reply Post Reply
Author
o2x4 View Drop Down
Member
Member


Joined: 03 November 2009
Status: Offline
Points: 21
Post Options Post Options   Thanks (0) Thanks(0)   Quote o2x4 Quote  Post ReplyReply Direct Link To This Post Topic: act pins cracking case
    Posted: 19 May 2010 at 12:36am
called tippman today they offered to replace the shell halfs. i told them it runs soo nice id rather not and can i run no bottom pin, they said yes no bottom pin but keep the top in. i figure the link arm may come up and out of place if not_popupControl();
Back to Top
Enos Shenk View Drop Down
Moderator Group
Moderator Group
Avatar
~-o@

Joined: 10 June 2002
Location: A comfy chair
Status: Offline
Points: 14109
Post Options Post Options   Thanks (0) Thanks(0)   Quote Enos Shenk Quote  Post ReplyReply Direct Link To This Post Posted: 18 May 2010 at 3:50pm
If you don't have the ACT system you should be able to safely remove those pins.
Back to Top
o2x4 View Drop Down
Member
Member


Joined: 03 November 2009
Status: Offline
Points: 21
Post Options Post Options   Thanks (0) Thanks(0)   Quote o2x4 Quote  Post ReplyReply Direct Link To This Post Posted: 18 May 2010 at 12:52am
sooo my act link arm pin is cracking into the rear bolt guide. im guessing that it is downward pressure from the link arm on the pin that is blowing out the holes. im thinking it may be because of my rufas dawg wicked bolt......

do i even need these pins? from what i understand they are for a act link arm. can i get rid of the bottom one?

  _popupControl();
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.172 seconds.