Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

Knife(s) project

 Post Reply Post Reply Page  <123
Author
Ceesman762 View Drop Down
Platinum Member
Platinum Member
Avatar
Time for a C-Section!

Joined: 15 November 2007
Location: United States
Status: Offline
Points: 4809
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ceesman762 Quote  Post ReplyReply Direct Link To This Post Posted: 24 November 2009 at 8:39am
Originally posted by ParielIsBack ParielIsBack wrote:

Originally posted by Ceesman762 Ceesman762 wrote:

Originally posted by ParielIsBack ParielIsBack wrote:

I'm assuming that's ceramic?  I would it wouldn't hold an edge or be easily sharpenable.
  who are you responding to Pariel?


You?

*EDIT* I totally destroyed that second sentence when editing my original post.  Meh.

Ok, no it is steel plate, Pariel.  the same stuff used on the LCAC.  Sneaky, a dwg file is fine too.
Innocence proves nothing
FUAC!!!!!


Back to Top
__sneaky__ View Drop Down
Platinum Member
Platinum Member
Avatar
Voted 2010 Most Improved Forumer

Joined: 14 January 2006
Location: Uncertain
Status: Offline
Points: 5285
Post Options Post Options   Thanks (0) Thanks(0)   Quote __sneaky__ Quote  Post ReplyReply Direct Link To This Post Posted: 24 November 2009 at 10:00am
Originally posted by Ceesman762 Ceesman762 wrote:

Originally posted by ParielIsBack ParielIsBack wrote:

Originally posted by Ceesman762 Ceesman762 wrote:

Originally posted by ParielIsBack ParielIsBack wrote:

I'm assuming that's ceramic?  I would it wouldn't hold an edge or be easily sharpenable.
  who are you responding to Pariel?


You?

*EDIT* I totally destroyed that second sentence when editing my original post.  Meh.

Ok, no it is steel plate, Pariel.  the same stuff used on the LCAC.  Sneaky, a dwg file is fine too.
How much you think it'd run me?Big smile I'll see if I can scrounge up the file when I get back home this afternoon.
"I AM a crossdresser." -Reb Cpl


Forum Vice President
Back to Top
Ceesman762 View Drop Down
Platinum Member
Platinum Member
Avatar
Time for a C-Section!

Joined: 15 November 2007
Location: United States
Status: Offline
Points: 4809
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ceesman762 Quote  Post ReplyReply Direct Link To This Post Posted: 24 November 2009 at 4:09pm
not a dime, when you have the dwg, pm me.
Innocence proves nothing
FUAC!!!!!


Back to Top
ParielIsBack View Drop Down
Platinum Member
Platinum Member
Avatar
future target of fratricide

Joined: 13 October 2008
Status: Offline
Points: 3782
Post Options Post Options   Thanks (0) Thanks(0)   Quote ParielIsBack Quote  Post ReplyReply Direct Link To This Post Posted: 24 November 2009 at 5:24pm
Oh, I'm a retard.

I assumed by ballistic plate you meant body armor.
BU Engineering 2012
Back to Top
 Post Reply Post Reply Page  <123
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.172 seconds.