X7 egrip not working in FA mode

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I posted in reply to a players egrip firing with the safety on.
I recieved a couple of emails asking me to post a fix for the X7 select fire
egrip not  working in the FA or Special Firing Mode setting.
This X7 had this complaint when I teched it. It is fine now. The image is from it.

Please note that this is not a Tippmann authorized repair to my knowledge.
Adjusting any sensor or switch on a circuit board incorrectly can cause damage.

Concern: Select fire Egrip shoots semi auto even when the FA is selected.

Cause: The Hall effect sensor used to sense the magnet in the selector lever
              is too far away from the lever to sense the magnet.

Remedy: Remove the egrip, remove safety lever and trigger assembly.
                 Use a non metal rod to push the sensor in the yellow circle below
                 against the trigger frame behind it. In the direction of the green pointer.
                 This is easy to do, do not press hard.

Reassemble your grip frame, install it and test.

(Mods, feel free to delete this if you feel it is not an advisable fix)

Hope this helps someone out.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
TinMan Members Profile Send Private Message Find Members Posts Add to Buddy List Gold Member Joined: 10 October 2007 Status: Offline Points: 1003	Post Options Post Reply Quote TinMan Report Post Thanks(0) Quote Reply Topic: X7 egrip not working in FA mode Posted: 25 August 2009 at 10:53pm
	I posted in reply to a players egrip firing with the safety on. I recieved a couple of emails asking me to post a fix for the X7 select fire egrip not working in the FA or Special Firing Mode setting. This X7 had this complaint when I teched it. It is fine now. The image is from it. Please note that this is not a Tippmann authorized repair to my knowledge. Adjusting any sensor or switch on a circuit board incorrectly can cause damage. Concern: Select fire Egrip shoots semi auto even when the FA is selected. Cause: The Hall effect sensor used to sense the magnet in the selector lever is too far away from the lever to sense the magnet. Remedy: Remove the egrip, remove safety lever and trigger assembly. Use a non metal rod to push the sensor in the yellow circle below against the trigger frame behind it. In the direction of the green pointer. This is easy to do, do not press hard. Reassemble your grip frame, install it and test. (Mods, feel free to delete this if you feel it is not an advisable fix) Hope this helps someone out.