X7 egrip not working in FA mode
Joined: 10 October 2007
Posted: 25 August 2009 at 10:53pm
I posted in reply to a players egrip firing with the safety on.
I recieved a couple of emails asking me to post a fix for the X7 select fire
egrip not working in the FA or Special Firing Mode setting.
This X7 had this complaint when I teched it. It is fine now. The image is from it.
Please note that this is not a Tippmann authorized repair to my knowledge.
Adjusting any sensor or switch on a circuit board incorrectly can cause damage.
Concern: Select fire Egrip shoots semi auto even when the FA is selected.
Cause: The Hall effect sensor used to sense the magnet in the selector lever
is too far away from the lever to sense the magnet.
Remedy: Remove the egrip, remove safety lever and trigger assembly.
Use a non metal rod to push the sensor in the yellow circle below
against the trigger frame behind it. In the direction of the green pointer.
This is easy to do, do not press hard.
Reassemble your grip frame, install it and test.
(Mods, feel free to delete this if you feel it is not an advisable fix)
Hope this helps someone out.
|Forum Jump||Forum Permissions
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum