Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

Re-cocking Problem

 Post Reply Post Reply
Author
Yurrix View Drop Down
Member
Member


Joined: 21 April 2006
Status: Offline
Points: 7
Post Options Post Options   Thanks (0) Thanks(0)   Quote Yurrix Quote  Post ReplyReply Direct Link To This Post Topic: Re-cocking Problem
    Posted: 05 May 2006 at 2:16pm
I recently purchased a LPK and Palmer stab for my Tippmann A-5.

The first 2 dozen or so shots were fine, but it now cycles about 4 or 5 times before recocking after a trigger pull.

I've checked the sear and rear bolt (brand new from the lpk kit), both are not rounded.

I tried putting a few drops of oil in the asa and fireing them through the gun.

Ive tried raising and lowering the pressure on the palmer, from ~300-500 without luck.

What i did find, was if I took the barrel off, and the FVA was flush (full power), it fired fine.  If the barrel was put back on (even holding it there without screwing it on) OR the FVA was adjusted in, the problem would re-surface.

So it appears to be a problem with back pressure or something.  I have no clue how to fix it, any suggestions would be awesome.

Ful specs:
Tippmann A-5
14" Lapco Snapshot
Low Pressure kit
Female Palmer Stab w/ 600psi gauge
Milsim Lapco Fore Grip
Lapco Universal Mount
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.125 seconds.