Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

A-5 Flatline Question---not the typical!!

 Post Reply Post Reply
Author
Craigers View Drop Down
Member
Member


Joined: 27 August 2005
Location: United States
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote Craigers Quote  Post ReplyReply Direct Link To This Post Topic: A-5 Flatline Question---not the typical!!
    Posted: 27 August 2005 at 11:09am
quick question for those that have one installed and working properly.

When you look at the barrel attached to the gun, and the top screw on the flatline is lined up with the sight, is your bottom screw slightly offset to the right?  or should that bottom screw line up with the top one?
Back to Top
JohnnyCanuck View Drop Down
Gold Member
Gold Member
Avatar
In soviet Canuckistan...

Joined: 08 July 2004
Location: Canada
Status: Offline
Points: 1361
Post Options Post Options   Thanks (0) Thanks(0)   Quote JohnnyCanuck Quote  Post ReplyReply Direct Link To This Post Posted: 27 August 2005 at 11:18am
I have an armson stealth shroud, both screws are lined up, shouldn't really matter though, if you have it twisted/locked into place, it should be fine.
Back to Top
Craigers View Drop Down
Member
Member


Joined: 27 August 2005
Location: United States
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote Craigers Quote  Post ReplyReply Direct Link To This Post Posted: 27 August 2005 at 11:51am
well my concern is that the offset screw hole will move the end of the barrel a bit pushing the barrel offcenter and resulting in bad shooting.
Back to Top
Craigers View Drop Down
Member
Member


Joined: 27 August 2005
Location: United States
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote Craigers Quote  Post ReplyReply Direct Link To This Post Posted: 01 September 2005 at 11:18am
any other opinions?
Back to Top
Roll Tide View Drop Down
Platinum Member
Platinum Member

NEVER had a STRIKE!

Joined: 18 September 2004
Location: United States
Status: Offline
Points: 2652
Post Options Post Options   Thanks (0) Thanks(0)   Quote Roll Tide Quote  Post ReplyReply Direct Link To This Post Posted: 01 September 2005 at 11:42am
If it changes the trajectory at all it will be very minor. I wouldn't worry unless the actual barrel is noticeably off center.
<Removed sig for violation of Clause 4 of the New Sig Rules>
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.156 seconds.