Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

Making an electro grip frame fit

 Post Reply Post Reply
Author
Texx View Drop Down
Member
Member
Avatar

Joined: 31 August 2002
Location: United States
Status: Offline
Points: 306
Post Options Post Options   Thanks (0) Thanks(0)   Quote Texx Quote  Post ReplyReply Direct Link To This Post Topic: Making an electro grip frame fit
    Posted: 06 August 2005 at 8:11pm
I have a JT 3.5 as a back up gun to my Tippmann. Nobody sells an electro grip for it, and I know for sure that Piranha grips don't fit it. I'm not sure about spyders though, I'll have to check.

My idea is to either: A) Do some cutting and drilling to try and make another brand's handle fit    or B) Take the guts out of another handle, and try to fit them into the existing one on the JT.

What do ya'll think? Any other ideas, or comments?

Texx

98c
16" Carbon Fiber
xchamber
RT
VL revolution 12volt w/xboard
Back to Top
Enos Shenk View Drop Down
Moderator Group
Moderator Group
Avatar
~-o@

Joined: 10 June 2002
Location: A comfy chair
Status: Offline
Points: 14109
Post Options Post Options   Thanks (0) Thanks(0)   Quote Enos Shenk Quote  Post ReplyReply Direct Link To This Post Posted: 06 August 2005 at 11:01pm
Its just a spyder clone, i doubt it would be difficult at all to adapt a spyder e-frame for it.
Back to Top
The Guy View Drop Down
Platinum Member
Platinum Member
Avatar
Soup Can Guy

Joined: 18 March 2004
Status: Offline
Points: 6664
Post Options Post Options   Thanks (0) Thanks(0)   Quote The Guy Quote  Post ReplyReply Direct Link To This Post Posted: 07 August 2005 at 12:32am
not hard at all. its already been done. I think the offset distance for a screw is off by maybe an 1/8".
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.203 seconds.