Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

LPK and CAR stock

 Post Reply Post Reply
Author
10kpbler View Drop Down
Member
Member
Avatar

Joined: 12 April 2005
Status: Offline
Points: 94
Post Options Post Options   Thanks (0) Thanks(0)   Quote 10kpbler Quote  Post ReplyReply Direct Link To This Post Topic: LPK and CAR stock
    Posted: 21 April 2005 at 8:48am
Someone told me to post this here...why not

I am trying to attach my CAR stock to my M98 that has an
LPK. I have several ideas, but the rear cocking is still
giving me troubles.

I think I have a method of cocking the gun when the rear
cocking device is covered by the stock, but to test this
method I need to take apart the new bolt/cocking device
that comes with the LPK.

So before I break anything, is there a way I can remove
the black cocking rod from the metal bolt, without
causeing any major damage. ie., any method that would not
require cutting, hacking and breaking?

How have the bolt and the cocking rod been connected
together. Have they been glued? Epoxied? Do both of them
have threads, so they can screw together?




Edited by 10kpbler
Model 98C
J&J 2P
Palmers Stab.
LPK w/side cocking mod
NW Drop w/on-off
RT w/silenced sear spring
Lapco Raised Sight Rail
Back to Top
LordJovian View Drop Down
Member
Member
Avatar

Joined: 01 June 2004
Location: United States
Status: Offline
Points: 1882
Post Options Post Options   Thanks (0) Thanks(0)   Quote LordJovian Quote  Post ReplyReply Direct Link To This Post Posted: 21 April 2005 at 11:51am

I don't have any experience with the 98C LPK, but I'd imagine from the pictures I've seen they have to be threaded together. I doubt they're just glued together (not a typical Tippmann method), more than likely they are threaded and sealed with loc-tite. Run it under hot water, put it in a vise with rubber (or something to prevent scratching) and try to get them apart. Is there a way to remove just the rod? If the rod comes out you can just put your regular cocking knob back in. I would imagine the rod is also threaded into the black portion of the bolt. Try to loosen that first, then work on the bolt. There may be some aftermarket rear low pressure bolts for the 98C, but it would be hard to find or not existent. Whatever the case, it would be a good mod to figure out.

Calling the Tippmann techs may also do you some good- they more than likely have run into this problem before, and you could even get lucky enough that Tippmann manufactures a normal LPK bolt that uses the standard cocking knob. Good luck!

A-5
E-grip
Chipley Custom Carbon Graphite 16"
Evil Adapter(Spyder)
32 Deg New '03 XChamber
Remote Line
Gun Sling
Sniper f/x Stock
LPK
68/4500 HPA
R-5
CP Reg
JCS Duel Trigger
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.156 seconds.