Tippmann Pneumatics Inc. Homepage
  FAQ FAQ  Forum Search   Register Register  Login Login

Buzzer

 Post Reply Post Reply
Author
Suuuch View Drop Down
Member
Member
Avatar

Joined: 23 May 2004
Location: United States
Status: Offline
Points: 7
Post Options Post Options   Thanks (0) Thanks(0)   Quote Suuuch Quote  Post ReplyReply Direct Link To This Post Topic: Buzzer
    Posted: 17 March 2005 at 5:40pm

My gun started buzzing and stuff so I checked the inside and the Spring for the sear was off so I put it back on. Then the grip wouldnt close and the gun still buzzes. I even changed the O ring when I put on the tank before I opened the gun. So what can I doo to close the gun and get it from buzzing. Can it be low Co2 or something else?

(Bumish) "Theres a Feeling I get When I look To the West" Jimmy Page/Robert Plant Stairway to Heaven
Back to Top
triggerhappy1 View Drop Down
Platinum Member
Platinum Member
Avatar

Joined: 07 May 2004
Location: United States
Status: Offline
Points: 3376
Post Options Post Options   Thanks (0) Thanks(0)   Quote triggerhappy1 Quote  Post ReplyReply Direct Link To This Post Posted: 17 March 2005 at 7:42pm

First separate the reciever halves and make sure everything is in, and in the right place. Compare your internals to the diagram in your manual to check.

A low CO2 tank will undoubtably cause this since there's not full pressure inside. Not enough to make a full cycle, and the rear bolt wont be blown back far enough to catch the sear and it will "bounce" back and fourth. So get your tank filled it it should not do this again untill empty again.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 10.03

This page was generated in 0.156 seconds.